DDR 200-pin SODIMM: Approximately 2.625 in. by 1.25 in. (66.7 mm by 31.75 mm)
DDR2 200-pin SODIMM: Approximately 2.625 in. by 1.18 in. (66.7 mm by 30 mm)
Do you have questions about this product?
get answers from real customers and in-house experts with AnswerBox.
Q:I am considering adding 1G or RAM to my 2006 MacBook Pro which currently has 1G. I was told that I would have to buy (2) 1G pieces of DDR2 because my MacBook would have to 512's in it.
A:Unfortunately I am unsure as to what memory is installed originally in that system. You could certainly check that by selecting the Apple Manu (Top left) -> About this Mac -> More Info -> Highlight the memory section -> The memory module in each slow should be displayed on the right hand side of the page.
A:I had a similar problem with my older Dell laptop. I needed to verify the pin count on the memory chip. I phoned Dell's Tech Support, in India by the way, and asked them. I needed the serial # and the service tag #, but the gave me the correct info. I then called and ordered through Crucial, saving 66%. Good luck. Thanks again Crucial.
Thanks for your message.
I have had a look in to this and unfortunately I have been unable to find an installation guide for this specific model. I would recommend contacting Acer directly who will be able to provide and installation guide for you.
I checked with the Acer website for an instruction manual but they don't have any listed. I am sure if you contact them directly they would be able to help.
Please let me know how it goes and if there is anything else we can help with.
I just got a new Crucial ct102464ba160b http://www.crucial.com/usa/en/ct102464ba160b
based on the suggestion here http://n40l.wikia.com/wiki/Memory that it is compatible with
HP Microserver N54L
My system runs fine the the original 2GB HP memory but when I put the Crucial stick in
it doesn't POST (can't see anything on the screen at all).
How do I check whether the RAM is not compatible or it's simply a DOA?
I ran the scan, it takes me to this page,
CT3694396 - 8GB DDR3 PC3-12800 Unbuffered NON-ECC 1.5V 1024Meg x 64
I have 2x Crucial DDR4's CT8G4DFD8213 in an Asus X99 Deluxe mother board with a Intel 5820K. System boots fine but only shows 8gb of memory in the POST and in BIOS only shows 8gb in DIMM_D1
I have the other 8gb in DIMM_B1 which is the reconmmend configuration for two DIMM's.
I have tried each DIMM in DIMM_D1 to confirm the memory is OK, which it is.
I also updated the BIOS reversion after my troubles to the latest version 904 though I didn't think it would really do anything as the change logs for the BIOS update seem to address other issues and not memory issues.
So I think this memory is maybe not compatible with the new Asus X99 Deluxe mother boards.
I am sorry for the issues that you are experiencing with your memory modules. I pulled up your system and it appears that these memory modules are compatible with your system. At this point I would test each stick individually to see if it just one defective stick. You may even try running each stick individually in the system to see if the error occurs. Please contact us directly, using the information in my signature, if you are still experiencing issues.